Chrysler Fault Code 53: Logic module fault

by Bob O’Neill and Bob Lincoln

Code 53 is triggered when there is a fault in the logic module. When code 53 is triggered the power limited will not be lit and the system will not enter limp mode.

Before replacing the logic module, read the page ‘How to troubleshoot drivability issues’. Check the wiring and connections from the logic module to the power module.   Clean and re-grease the connectors with dielectric grease. Check the wiring from the O2 sensor to the harness. If the signal wire is grounded it will cause code 53. If that all fails, you may need to replace the logic module.

Sensors, Switches, and Other Systems | Main Repairs Page | EEKs

Disclaimer: The information provided in this and linked pages are intended for informational use and are provided as accurate to the best of our knowledge.  Neither the author nor Allpar.com is to be held responsible for their contents or the use of the information by you the reader. THE INFORMATION IS OFFERED “AS IS” FOR INFORMATIONAL PURPOSES AND WITHOUT WARRANTIES OF ANY KIND EITHER EXPRESSED OR IMPLIED. IF YOU USE THIS INFORMATION YOU RELEASE THE AUTHOR AND ALLPAR.COM FROM ANY LIABILITY WHATSOEVER.