Note: Allpar does not take responsibility for the veracity of any information or opinions here, does not claim expertise, and is not responsible for any consequences. Please proceed at your own risk.
Courtesy of “Skidsmadawg96”
Link: How to get the codes if the following instructions don't work
To get the codes, cycle the ignition key On - Off - On - Off – On within 5 seconds. The odometer will show the P-code. If there are no codes, “Done” will appear. A code P1684 shows that the memory has been cleared recently and is not necessarily a problem. More instructions and other code lists.
We are linking errors to specific help pages as an ongoing project.
On this page, MAF = mass airflow, MAP = manifold absolute pressure. Few Chrysler vehicles use an MAF. MAP sensors have a tendency to fail without setting codes.
We strive for accuracy but we are not necessarily experts or authorities on the subject. Neither the author nor Allpar.com / Allpar, LLC may be held responsible for the use of the information or advice, implied or otherwise, on this site. This page is offered “AS IS” and without warranties. By reading further, you release the author and Allpar, LLC from any liability.
More Mopar Car and Truck News
2007 Pacifica • Chinese Hongqi CA770: allegedly based on the... • Dodge Demon hints...
Chrysler, Plymouth, Dodge, and Jeep car, minivan, and truck computer fault codes: how to get them and what to do with them. Good for sensor and other troubleshooting.