AF: 300M harness routing | Allpar Forums
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

300M harness routing

Discussion in 'LH: Large Cars, 1993-2004' started by Tomguy, Feb 19, 2020.

  1. Tomguy

    Tomguy Well-Known Member

    Joined:
    Oct 4, 2011
    Messages:
    1,240
    Likes:
    935
    Good evening,

    I am looking to see if anyone can share a diagram or picture(s) of the harness routing, specifically for the harness that connects by the brake booster / master, and runs down to the transmission.

    I thought I knew how to route this around my tie rods / steering gear, but it's clearly wrong as I can see it's been rubbing.

    Thanks!
     
  2. ImperialCrown

    ImperialCrown Moderator
    Level III Supporter

    Joined:
    Jun 8, 2008
    Messages:
    21,196
    Likes:
    4,399
  3. Tomguy

    Tomguy Well-Known Member

    Joined:
    Oct 4, 2011
    Messages:
    1,240
    Likes:
    935
    Thanks, I had seen those, but none show how it routes around the rack.

    I think I found the issue in a zip tie that was unsnapped, on the back of the engine block (left side). I snapped the harness back in, and tied it up and around the rack, I think it should be good now.
     

Share This Page

Loading...
 We are not affiliated with FCA. We make no claims regarding validity or accuracy of information or advice. Copyright © VerticalScope Inc. All rights reserved.