NewsDemon has a freakin’ TransBrake • Pritchett’s Challenger Drag Pak isn’t a Demon • Ram Longhorn to match trailers

Hello, Allpar Forums member or visitor! If you were a member, you would not see this ad!

Register or log in at the top right of the page...

  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Starting on a '55 Plymouth Plaza Suburban

Discussion in 'Other classic cars' started by 71Charger_fan, Nov 26, 2016.

  1. 71Charger_fan

    71Charger_fan Member

    Likes:
    42
    Too cold in the garage this weekend, so I brought the grill pieces into the family room and assembled it inside.
    IMG_0653.JPG
     
    saltydog likes this.
  2. 71Charger_fan

    71Charger_fan Member

    Likes:
    42
  3. 71Charger_fan

    71Charger_fan Member

    Likes:
    42
    I put the dash back in and am checking the circuits one by one. Wipers don't work, so I have to trouble shoot that.
    Plaza dash in.jpg Plaza radio check.jpg
     
    dana44 and stroudtom like this.
  4. 71Charger_fan

    71Charger_fan Member

    Likes:
    42
    Although the 6V starter should work fine on 12V, I have no idea how old it is. I was lucky enough to find a 12V starter for a '56, so I'm going to install that. Plaza 12V starter.jpg
     
    saltydog likes this.
  5. geraldg

    geraldg Active Member Ad-Free Member

    Likes:
    585
    You are going to change that single master cylinder to a dual setup, I hope.
     
  6. 71Charger_fan

    71Charger_fan Member

    Likes:
    42
    Got one coming. Distribution/metering valve came today. Rotors, calipers, and hoses came this past week. Need the weather to warm back up so I can get back to it.