Allpar Forums banner

Forum Discussions about this Product

1 - 2 of 2 Posts
    1. · Registered
      Joined
      ·
      174 Posts
      Don't forget the tank grommet, Dorman Products - 577-500 .

      Also, you probably know this, but I just wanted to mention that, while you're putting the hose clamps on, put the "worm gear" at the BOTTOM so the bed will fit down properly. Took about three tries to figure that out for me.

      If I were to redo mine today, I'd look hard at these clamps: Breeze Constant-Torque Stainless Steel Hose Clamp, Worm-Drive, SAE Size 24, 1-1/16" to 2" Diameter Range, 9/16" Band Width (Pack of 10): Worm Gear Hose Clamps: Amazon.com: Industrial & Scientific .

      RwP
       
    2. · Super Moderator
      Joined
      ·
      12,313 Posts
      Discussion Starter · #9 ·
      Don't forget the tank grommet, Dorman Products - 577-500 .

      Also, you probably know this, but I just wanted to mention that, while you're putting the hose clamps on, put the "worm gear" at the BOTTOM so the bed will fit down properly. Took about three tries to figure that out for me.

      If I were to redo mine today, I'd look hard at these clamps: Breeze Constant-Torque Stainless Steel Hose Clamp, Worm-Drive, SAE Size 24, 1-1/16" to 2" Diameter Range, 9/16" Band Width (Pack of 10): Worm Gear Hose Clamps: Amazon.com: Industrial & Scientific .

      RwP
      Fuel pump was just replaced along with tank grommet.

      What do you mean about the bed fitting properly? The bed doesn't come off for this job. There is a lot of clearance around the filler neck from underneath.
       
1 - 2 of 2 Posts

Forum Reviews

Be the first to review this product

Write a Review

Do you have experience with this item? Help our community members and share your knowledge.

Sign in to add review

Top