Search Results for ‘chryslerptcruiser’

Hello, so some of you may have seen my post about my 02 PT having low compression on a cylinder, so I'm starting to research pulling the engine out and getting a used engine for it. What's the best way to get the engine out from the top? I don't want to do it from the bottom as I don't have a...

Hello, today I decided to fix my PT's exhaust leak, but while under there I noticed that the upper section of the exhaust as shown in the video is being hung up by wire. Where is an actual hanger supposed to be? The only 2 places it was hung in a factory hanger was in the rear by the muffler...

Hello, so on my new automatic 02 PT with 140k miles I decided to do a compression test today, just to get a slight idea of the engine's health. It runs decent with a possible slight idle misfire. Cylinder's 1-3 all good at 150-155psi compression. However, cylinder 4 is down quite a lot. In the...

Hello all! A few days ago I bought an automatic 02 PT Cruiser with 138k miles after selling my manual one that had over 200k! The car has been smooth sailing so far, just put in new shocks to replace the horribly bouncy OEM ones. However, I'm noticing a slight steering problem. The steering...

Hello, so this week I went to go replace the sway bar bushings. To sum it up its been a disaster... 3 out of 4 of the bracket bolts broke and the 4th is rounded off. So I drilled out 2 of the holes in hopes to get a bolt and nut onto it, however realized that wouldn't work because there's no...

Hi so I've never jacked my 2004 PT cruiser before and today I need to jack it from the front. Is there a good place in the middle front to jack from? Like a crossmember or something? If thats not possible where do i jack it from one side on the front? I know in the back theres a triangle then...

Hi, so recently I've noticed that my shifter seems a bit loose, here is a video explaining everything. Excuse the mess in the car I went to McDonald's with some friends and am yet to clean it out lol. Any advice would be greatly appreciated. Thanks! Video Link

Hi, so on my 2004 PT Cruiser I’m noticing very small amounts of coolant by the belt, which is getting into the belt and making it nice and squeaky. I’m aware I may have to replace the belt now, but I want to fix the small coolant leak before that for obvious reasons. In the picture attached I...

Hi, so I've been noticing that my 2004 PT Cruiser's muffler has been lower than usual, and today I decided to finally give her a peak, when this is what I noticed... Anyone got any advice for super cheap DIY fix for this to get it back where it should be? I don't want to get crap welded and...