Allpar Forums banner

limp mode

  1. Repairs, Maintenance, Help
    I've had the almost exact same experience as this thread: 07Sebring codes 700/765 looking for shop in Albany, NY area (at https://www.allpar.com/forums/threads/07sebring-codes-700-765-looking-for-shop-in-albany-ny-area.217841/ ) Didn't want to muddy that thread, so starting new one specific to...
  2. Repairs, Maintenance, Help
    SITUATION 2008 Jeep Grand Cherokee North Edition (Limited?) 3.0L CRD (MB OM642), 152,000 miles, GDE Eco Tune - "Delete" since bought used in 2015. At the end of a 2.5 hr drive (avg 75 MPH), hit a heavy downpour, at the end of which, the Electronic Throttle Control warning light (lightning bolt)...
  3. Repairs, Maintenance, Help
    I got the code po369 after replacing left side rockers so I changed the sensor camshaft and have checked the wiring its driving me crazy with it being in like a limp mode. any help would be great thanks.
  4. Repairs, Maintenance, Help
    This is using a 1991 SBEC with a modified calibration. I just finally got the SBED to work correctly as far as "waking up" on input from the distributor HEPs. I went ahead an put some ethanol free premium gas in the tank, ran a jumper from the bulkhead connector to the left side body harness to...
  5. Repairs, Maintenance, Help
    I have a 06 pt cruiser, and any time I try to use either the windshield washer, or rear wiper or washer, it puts the car into limp mode. All I have to do is shut the car offor and restart it to get out of limp mode. Any suggestions on what could cause this?
  6. Repairs, Maintenance, Help
    Hi all. I have a 93 LeBaron V6 3.0L with 56k miles. Previous owner replaced a few parts including PCM and I saw a few female connectors that are in the wiring bundle close to the PCM not plugged in to anything. Are they supposed to be plugged in or are they just there to hang out with no...
Top