Allpar Forums banner

suspension

  1. Neon
    Just starting out Neon circle track racing. Having driven street rear wheel pickups & semis for almost 30 years, I'm struggling to handle front wheel racing loose feel. Therefore losing out on comparative speed. Rear springs cut to lower, some front camber added, tires 195/60/R14, stock 5-slot...
  2. Repairs, Maintenance, Help
    I recently replaced both upper and lower control arms, tie rod ends, link pins, wheel bearings, brakes, and struts and bushings. I did this because I needed ball joints they were starting to go out and my struts started making noise so I replaced them even though I believe the problem was only...
  3. Vans
    Ok, so I've looked high and low and found nothing on the forums or net in general. Vehicle:1977 pb300 sportsman maxivan #3300 front axle My issue: Front Upper Control Arm Ball Joint failure means new front upper CA assy is needed. Conflict: I cant find 'vehicle specific' replacements but...
  4. Minivans · Pacifica
    I just bought my first Grand Caravan. It's an 05 SXT with a 3.8 with 140,000 miles. While driving with the gear selector in "D", when it hits cruising gear and you have slight pressure on the accelerator to maintain speed, the right front begins to shudder like a tire is bouncing or vibrating...
  5. Parts Wanted
    If you are parting out any of the above cars I need the steering knuckles to go 5 wheel lug and heavy duty front wheel bearings on an 88 Horizon.
  6. L: Horizon/Omni, Rampage, etc
    I went looking at an 89 LeBaron convertible for the chance of pulling the control arms for one of my Horizons (88 and 89). The 89 LeBaron has the stamped steel control arm without the stub axle. It has a riveted on rear extension with a cylindrical bushing like the front. This is intermediate...
  7. Compacts: Renegade, Patriot, Compass, Caliber
    Put the Renegade Trailhawk on the lift today. Checked out some of the fasteners, lots and lots of E-Torx, fair amount of regular Torx, quite a few six-point. One captive-nut on the rear-end that I expect will be a headache for people servicing dirty vehicles. E18, E16, E14, all...
  8. 1995-2017 FWD Sedans, Coupes
    Looking to upgrade/smooth out the suspension on my 2007 Chrysler Sebring Limited that the previous owner replaced the struts with moneroe sensatrac quick stuts and ruined the ride (too stiff and strut mounts seem to rattle, had same problem with 1996 LH that had monroe quick struts) with 2014...
Top