Allpar Forums banner
1 - 1 of 1 Posts

·
Premium Member
Joined
·
6,090 Posts
I believe MAC tools has the puller to do it. There is a topic with a picture of the puller, which is like a tripod with three places for lug bolts/nuts to be attached to the base and then a bolt and a hammerhead piece that attaches to the end of a bolt that will be tightened against the axle end. You use a sledge hammer to tighten the drum puller, then you use a wheel puller to pull the axle from the housing.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top