Allpar Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hey guys,

I am trying to install a dual reservoir master cylinder into my 63 dart. I did a lot of research and found one with the same bolt patter as the original master cylinder. I'm new to brake parts. I am trying to figure out how the plunger fits into the new master cylinder. There is a rubber piece in the new master cylinder that looks like the plunger is supposed to fit in. Is the piece attached to the end of the plunger (the rod that connects to the pedal) able to be removed?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top