Allpar Forums banner
1 - 2 of 7 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Recently purchased used 1996 T&C LXi 3.8L van with 250k+ miles....have been very happy/lucky after having used it to drive 2,800 miles cross country to move; with one major exception:

1a) Stalls soon after starting...no error codes readable as dash is digital (analog guages for tach, etc. are appear dead). The couple past incidences have been solved by just letting it set for an hour or two and then everything works fine....just missed a job interview this morning and doesn't seem to be 'self correcting' today.

1b) Another behavior, while driving, might be related and help to troubleshoot. A couple times while driving, around town and on highway, the guages and odometer has gone dead while the vehicle kept driving fine. This condition also reset itself both times within
 

· Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Thanks John, I'll check into that. I understand how bad solder joints would impact the gauges, etc., but are you suggesting this possible problem would also be leading to the stall soon after starting?
 
1 - 2 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top