Allpar Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
8 Posts
Check the camshaft sensor, fuel pressure *should be above 50psi*.

Spark plugs are simple to get to.

Remove the air cleaner box top, elbow. Intake Temp sensor relay,.

Remove the 3 botls holding the throttle body in place

Remove PCV hose, disconnect the wires/hoses going into the upper intake.

Pop off the throttle line cover, and move the wires back.

Take out the 5-6 bolts on the front of the upper manifold, and pull it on out. *be careful not to break strech the throttle and Cruise lines*

Take care not to lose the seals inside the upper manifold :) or get anything down into the lower manifold :)

Then youll have open access to the plugs .
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top