Allpar Forums banner
1 - 1 of 1 Posts

·
Registered
2017 Ram 1500 3.6 Crew
Joined
·
7,018 Posts
It is quite possible that the new points had something on the contact surface creating a less than perfect contact. I have found that on the last two contacts I purchased. Sometimes just passing a clean white (non-treated) paper across the closed points will clean them. An ohmmeter will tell the story. There must be "0" resistance across the points for proper operation.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top