Allpar Forums banner

3.5 motor noise in 2004 concorde lxi

1725 6
looking at a 2004 concorde lxi

the motor has a bit of a knock/rattle in it.

Sounds low in the engine but i can only hear it clearly on the drivers side and it almost sounds like it is coming from the rear of the engine but is a bit hard to tell. It is also a bit intermittent and seemed to fluctuate a bit with the AC on and when shifted from R to N to D and back and forth.

didn't really make any noise when first started "cold" kinda cool here today.

Anyone run into this before? likely rod knock or flywheel/torque converter noise or something else???


Thanks.
1 - 4 of 4 Posts

·
Registered
Joined
·
276 Posts
Discussion Starter · #3 ·
Flexplate?
 

·
Registered
Joined
·
276 Posts
Discussion Starter · #5 ·
I thought that you probably meant flywheel.

In my quest to replace the 2003 Intrepid ES that was totaled (thinking now I should have bought back) i've come across several 3.5's that have "rod knock". Have only heard one and it was toast, rattle on top and knocking bad on bottom, I think the kid that had it run out of oil. looked at it as a possible car to put a new motor in but he had trashed the whole thing. This Concorde was advertised with motor problems. Was surprised when 1st started it didn't make any noise at all. then the slight wrapping noise on the drivers side near the rear of the engine.

If a flywheel is there any way to check under load (sitting still and carefully power braking)? would the load make is worse??

To your 1st post. The car is very clean with only a couple battle scars/parking lot dings but not many really. newish goodyears all around 122000 miles. their asking 1900 but I'd try to go lower. Even with a new (used) motor at $500 (local rate) that's not a bad price other than alot of labor (mine) to fix it.

It does idle a bit rough and lopes a bit idling.

Thanks again for the help
 

·
Registered
Joined
·
276 Posts
Discussion Starter · #7 ·
Thanks for the feedback.

Might go take another look Sat if I can get over there.

Car is really nice shape but not sure I want to tackle a motor right now. Even though it would still be a good deal.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top