Allpar Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Great day to all.I am new to site and new to gas mopar engines I built a jeep and put a 360 in it. The motor came out of 85 dodge d350 dually with granny 4 speed. My problem is i thought orignal distributor was bad because there was slop and weights fell apart when i took cap off but it ran really good. so I bought a new one just stock reman from a parts store because it was day before event. ever since then it runs like crap no power if i retard it 10 degrees it runs but down on power. when i put the distibutor in the slot the rotor is still sloppy with new distributor could the gear slot be sloppy. The dis gear to cam gear does not seem to be but could the slot be sloppy? i know chevy engines pretty good and i have never seen one do this is this normal for mopar? can i pull the cam dis gear without pulling the intake? thank you in advance i really apreciate it.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top