Allpar Forums banner

63 Dodge universal dust boot installation

2539 6
The rubber dust boot disintigrated. I have a replacement and need help installing the replacement. I am not replacing the universal. The repair manual is not very helpful. Any suggestions?
1 - 2 of 2 Posts

·
KOG
Joined
·
1,907 Posts
I think it can be slipped over the pin. That pin has to be centered to within a few thousands, forget the exact spec, but you must have a press, a hammer just ain't gonna get it at all if you have to move the pin.

I had a couple of 62s, but it's been a looong time since then.
 

·
KOG
Joined
·
1,907 Posts
They're somewhat similar to a steering pot joint as well. Inboard CV joints usually have three balls and the RWD driveshafts have two.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top