Allpar Forums banner

63 Dodge universal dust boot installation

2542 6
The rubber dust boot disintigrated. I have a replacement and need help installing the replacement. I am not replacing the universal. The repair manual is not very helpful. Any suggestions?
1 - 2 of 2 Posts

·
Premium Member
Joined
·
1,750 Posts
I moved this topic to General Tech Support for more readership 'traffic'. :)
 

·
Premium Member
Joined
·
1,750 Posts
68RT said:
You should be able to slide the boot over the pin after removing the balls. DO NOT LOSE THE NEEDLES. As you slide the balls off, push some grease into the needles before they get off of the pin to help hold them in place. It will save you a lot of time.
I've never had a Trunnion driveshaft rebuilt admittedly; but your description sure reminds me of an inboard C/V joint. :)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top