Allpar Forums banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
6,086 Posts
They are not moulded into the plastic, they are removable. If you look at the connection side where the female enters the terminal, there is a small little groove. Take a paper clip and flatten or file a flat on it to make it thin enough, then push the electrical wire into the plastic then slide the paper clip into the groove, there is a little tab that will depress and the wire will then pull out the back. NAPA carries the proper connections in boxes and are not on display, and to prevent there being problems in the future, dielectric grease is the best thing to help prevent them from corroding and getting water contamination due to its location.
 

·
Premium Member
Joined
·
6,086 Posts
It's there, If you have some kind of spare in a connector, yank it out, look at it and reverse engineer to get them out, I did my whole 68 Charger this way so I know for a fact they come out.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top