Allpar Forums banner
1 - 2 of 4 Posts

· Registered
Joined
·
525 Posts
Discussion Starter · #1 ·
Hey guys....

Just fixed my minivans timing belt problem, flushed the tranny and power steering and of course engine oil and coolant.
Runs fine, trans shifts great (after flushing it -> the Dexron thing) and everything works.

Now a strange problem. There´s water dripping out between the cylinder heads / underneath the intake manifold on the transmission´s side.

Could it be the water pipe from the pump?
The pipe was movable, not firmly connected like i thought.

What could it be and if the problem is the pipe, do i have to remove the belt / pump etc again? Please tell m no....

Thanks a lot!

Kevin
 

· Registered
Joined
·
525 Posts
Discussion Starter · #4 ·
Finally a update....i checked both O rings....replaced the one on the transmission side....but both were OK.....and now it comes.....cracked thermostat housing. I checked it for leaks first, nothing....while replacing the o rings and building together the intake manifold....i saw the little crack. Water was flowing through under the intake manifold, anding up on the trans....

Anyway, thanks for help guys, i really appreciate it!
 
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top