Allpar Forums banner

'80 B200 van steering box issues

2320 Views 5 Replies 3 Participants Last post by  Dodgey Ben
So i installed different steering box out of a junk yard in my b200 (318) camper style van. After I had it all back together the steering wheel rolls to the right automatically when you start the van, just parked there. Thought I grabbed a bad steering box so I went and exchanged it but no luck the other one leaked around the spline. So i put the other one that pulls the wheel a little bit back in. Figured it was better than a leaky one. My question is does anyone know if there is a valve to be replaced that will fix the steering pull issue or something that will fix this issue. Or should i just get a brand new steering box?
1 - 2 of 2 Posts

· KOG
Joined
·
1,912 Posts
The procedure to center the valve is to start the engine and watch which way the wheel kicks as the engine starts. When the valve is centered the wheel will remain motionless during engine start.
 

· KOG
Joined
·
1,912 Posts
It moves enough to center the valve.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top