Allpar Forums banner

99 reciever drier

1911 Views 2 Replies 2 Participants Last post by  AJ_Schreiber
just went to replace it and couldn't remember which way it goes on. I'd hate to install it backwards. anyone have a diagram or way to explain which way it goes?
1 - 3 of 3 Posts

· Super Moderator
1966 Crown Coupe, 2016 200 S AWD, 1962 Lark Daytona V8.
Joined
·
17,308 Posts
Is there an arrow stamped on it? Is this a Mopar dryer bottle? Are the in and out fittings the same size? Many times they are made different to be error-proof.
 

· Registered
Joined
·
67 Posts
Discussion Starter · #3 ·
I installed it the way I remembered the old one and all worked correctly. This was a Murray brand Drier and no arrows what so ever. I can only assume the lines wouldnt fit if tried to put the other way. The original Mopar one didnt lend any clues either which was mildly annoying
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top