Allpar Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
Hello again, Its been a while.
My new shop is coming along slowly but it's getting there.
The interior (all of it) of my 73 Charger is a shade of green that I just don't like. The seats were redone several years ago and the vinyl is still in GREAT condition.
My question is......The aerosol (or cans to use with a spray gun) vinyl dies that are advertised in the restore catalogs, Are they any good? Does the stuff work as advertised? or is it just more a waste of money and time?
Looking at changing the color and was just wondering if I should just pay for new material and recover the seats.
Any insight would be helpful, I've never used this kinda stuff.
Thanks in advance,
NewParOwner
 

·
Registered
Joined
·
15 Posts
Discussion Starter · #3 ·
Thanks Bob, I have been a little skeptical about the stuff, since chances are I will replace with New.....I may give it a try.
Kinda 'test drive" it. It will be a while before I am actually ready for the seats to be installed anyway. I may use on 1 seat and let it stand for a while and check it out. there might be a use for it in other areas.
Thanks for the reply.
 

·
Registered
Joined
·
15 Posts
Discussion Starter · #5 ·
Thanks Covertopps. That is good news to hear. Where is that brand available? I want to get a brand that somebody has good things to say about it. As far as the seats go, I will still probably just have those recovered.

Thanks again.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top