Allpar Forums banner

AWD driveshaft boot

1853 Views 2 Replies 2 Participants Last post by  98gcawd
Who has the front boot for the driveshaft that runs between the power transfer unit and the over running clutch? I looked on NAPA's website and they didn't have a listing.
1 - 3 of 3 Posts

· Super Moderator
1966 Crown Coupe, 2016 200 S AWD, 1962 Lark Daytona V8.
17,284 Posts
I don't think that the dealer even services these driveshafts. We usually sent them out to a driveshaft/u-joint shop for rebuild.
You could try to see if a manufacturer name and part # are printed on the boot.
A vendor like Hardy-Spicer or GKN might have manufactured them for Chrysler.

· Registered
96 Posts
Discussion Starter · #3 ·
GKN sounds familiar. I'll be checking it out tomorrow. Any problems with running it without the driveshaft? I don't need AWD this time of year.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.