Allpar Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hi yall,
I am having a problem with my 1996 Dodge B2500 conversion van, 318. When I start it up cold, it runs perfectly. As it warms up it will stall and after a second or two, start running again. If I'm at a stop it will die, but start right back up. After about 20 minutes it will run perfectly and give no more problems unless I let it cool off for several hours. I've replaced plugs, wires, cap, rotor, ignition pick-up plate, and was looking at the coil, even though it checks out allright.It has several codes in memory, but they all seem to be nonsense codes(fuel pump relay, camshaft sensor, trans temp sensor, hall effect) and to me it looks like smec but I don't know for sure.
I've worked most of my life on GM products so I'm a little out of my league here. Any ideas?
Thanks, Gayle.
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #4 ·
Thanks for the thoughts, I found a bad wire on the crank sensor, run like a champ foe a while. Now it's starting to act up again, different this time, so here I go again!
Gayle
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #6 ·
Nope, no trouble codes, found bare wires on 3 wire plug on side of trans were shorting. Taped them up and everything seems good. I kind of wonder if trans was kicking out and not engine. It just happened cruising down the road, like a big clunk then go again. Feels good now I'll let you know if it happens again. For now it works good. I do appreciate all the ideas and help. Gayle
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top