Allpar Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hey.

I have a '97 Grand Cherokee with no brake lights and am looking for some advice. I have checked the fuse / good. - tested the brake lamp switch / good - I have 2.9 volts at two of the pins in the connector that is located inside the left rear interior pannel at the LH tail lamp. There are no indicator lit up on the VIC. I can lite both tail lamps with my power probe. It seems to be a problem on the ground side if I had to guess. Does the VIC or any other module have anything to do with this problem ? Any help would be greatly appreciated !!!!

Thanks !
Wayne
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top