Allpar Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,102 Posts
If you have the original master cylinder it will most likely be aluminium. You shouldn't have a problem loosening the brake line fittings if you use the proper size flare nut type of wrench. It may help to spray some penetrating oil on the fittings a day or so in advance to help loosen things up.
Most of the replacement master cylinders I've seen have been made out of cast iron. It may be possible to just get a rebuild kit for yours.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top