Allpar Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I just finished installing a 440 in my belvedere with a 727 auto trans. the motor and trans has been setting for about 8m,when I finished the install and put trans fluid in it.it only stays in a forward gear regardless were I have the shifter set.I looked under the car and the shifter is moving the trans shifter arm like it should any ideas?????
 

·
Registered
Joined
·
560 Posts
Did you fill the torque converter with tranny fluid before installing it? Is there a clear path through the tranny cooler for fluid flow? (This won't prevent operation) Is there any fluid flow through the cooler lines? This tells you that the pump is working.
 
1 - 2 of 2 Posts
Top