Allpar Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
485 Posts
Discussion Starter · #1 ·
Hello! My rebuilder tells me the bolt that bolts into the crank sprocket is not deep enough. I cannot understand what the problem is, as all the bolts were with the engine when it went into the shop for rebuilding. I guess I should mention the engine is a 2.5 4 cylinder from 1989.

If anyone can help me regarding the length of that bolt, I would be most appreciative. This is the only thing holding up putting the engine into my van.

If there is a location where this information is readily available online, do let me know as well.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top