Allpar Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I recently purchased 2 remanufactured cylinder heads for a dodge 360 engine. Placed them on the Van, the bell shaped ports has a small edge at the top exposed after intake manifold was applied. Is this ok or whats going on....Roaddog770
 

·
Premium Member
Joined
·
20,080 Posts
Is the engine a 318? This is one of the reasons I am always against installing 360 heads on a 318, the intake ports for the 318 are smaller and the intake manifold is smaller ports so the gaskets/ports don't match. It also drops your compression lower than a low compression 318. If you insist on using the 360 heads on the 318, you need to install a 360 intake to prevent intake leaks.
 

·
DO NOT FEED THE TROLLS!
Joined
·
8,808 Posts
Are these on the center at the heat crossover? If so that's normal.
 
1 - 3 of 3 Posts
Top