Allpar Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
34 Posts
I used a cutoff wheel and took a nice slice off the back of the knuckle. You onlyb have to cut the top of it and you should cut it on a bit of an angle. take little bits at a time. I can't measure my camber in degrees anymore. I'm 3-1/2 inches off plumb!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top