Allpar Forums banner
1 - 2 of 2 Posts

·
Mopar starship captain
Joined
·
4,233 Posts
I've replaced the driver's door hinge pins twice on my LeBaron Coupe. With a helper and a floor jack or two, I drove out the old hinge pins without removing the hinge from the hinge plate. I like gearhead's idea for hinge pin replacement better. I used the Help! kit twice and the current pin is already worn out. But then on the other hand, I was replacing pins every five years, so it's actually due. I've had the car ten years. However, since the car is very clearly near the end of its life, I probably won't do a third hinge pin replacement.
 

·
Mopar starship captain
Joined
·
4,233 Posts
the Q/C of the Dorman/help! brand pins does vary greatly from my experiance, first ones were very soft and easy to drill the guide hole into
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top