Allpar Forums banner
1 - 1 of 1 Posts

·
Premium Member
Joined
·
20,348 Posts
Place a 2X4 or 2X6 under the oil pan and jack it up with a floor jack. Take it up about an inch, then remove the two motor mount bolts, then raise the engine several more inches so the mounts are several inches above the mounting locations. If you can stick a 2X4 between the mounts the pan will clear the crank.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top