Allpar Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
31 Posts
i just replaced mine to pass a safety inspection.left one was a beast to replace,the nut inside the frame tore loose from its mooring.
pull carpet back,a dimple in floorboard directly above bolt indicates where to bore a hole with a holesaw-i used two inch holesaw and a cordless drill.

then i welded the nut to the frame,while it was still hot i hit the bolt with the impact and got it apart.
it doesent knock on the floor anymore.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top