Allpar Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
I removed the cables that control the operation of the heater. Now I can't figure out where one goes. I know the center cable goes over the heater box and the cable on the right (the short cable) goes just behind the panel and controls if air goes to the defroster vents. Where does the third cable go? The cable that also has the switch to turn the fan speed?

Thanks.
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #3 ·
I have not tried again. Will do so later today. Working hard to get this back together before my father gets here tomorrow night. It was his car. I will get a service manual. Odd I took these off and the dash just insn't THAT BIG.. Should be able to see where it goes. Thanks for replying. I'll have to get into this site a little more. Learned a bunch on this project! Norman
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top