Allpar Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I have a 2006 pt cruiser gt turbo. It the transmission keeps going into limp mode. After I clear the codes it works fine but if I hit the gas completely to get around someone it falls on it’s face and pops up a misfire code. Now with the being said i just did a full tune up new plugs wire and coil also new injectors. I have a feeling it’s tipm related because once the car has been driven for awhile and you come to a stop the car dies. Ac also doesn’t work which Iv been told is all signs of tipm failure. Is there anything else I can do before I just start replacing the expensive stuff. Alternator is good and charging good and had a new battery to. Please any help is appreciate
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #6 ·
Check the condition of the ground points. A corroded ground will reduce the voltage passing through and cause a low voltage condition. One area of interest would be the ground points on the driver side fender. You will need to remove the air box to get a good look.
Yep just did that and replaced the thermals because they were very bad and falling apart also put a tipm from a non turbo car in it is that ok since my car is turbo
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top