Allpar Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
191 Posts
Discussion Starter · #1 ·
I have a 2010 Chrysler 300 and the oem lights are quite poor, has anyone had sucess with the aftermarket HID lights. The following is an example of what i was thinking of using. They call this a CAN bus compatible unit, but I am assuming that in the car there is a "load center" that monitors current to the lights and then sends a message via CAN to the dash if there is a problem. So this unit would draw the same current as the oem lights so the load center does not send a fault code???

http://www.ultrahid.com/cahidkitp.html
 
1 - 1 of 1 Posts
Top