Allpar Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
In order to get my 78 b300 motorhome to pass an inspection I had to fix the high beam indicator, I pulled the connector to the panel and found that all but 3 pins stayed in the connector and one that was left was really loose, is there a way to reattach the pins ? I thought of epoxying some wire/nail thing to go down the centre and soldering the pins back to that and the circuit board, i have looked at used clusters but need a Canadian one in km/hr
 

·
Super Moderator
1966 Crown Coupe, 2016 200 S AWD, 1962 Lark Daytona V8.
Joined
·
22,724 Posts
These terminal pins are staked into the c/board? You may be able to re-stake them and then solder them in for a secure connection.
 
1 - 2 of 2 Posts
Top