Allpar Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
9,338 Posts
I did the slide replacements on my 99 GC and didn't find it all that complex. You just have to make sure you replace them one at a time, clean the spring and the hole, and then put the same letter slide back in the same slot. If not, your key will not work. I noticed this after the second slide I removed. I pulled first one out and noticed that it was NOT the same letter. I put the same letter one in the slot and after I got them all done, reinserted the switch and is worked like a charm. AND the key in ignition feature worked again too!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top