So one bolt hits the frame and one bolt is on the inside and even if off the pulley wont slide out. Is there a trick to getting the belt tentioner pulley off without removing the power steering pump and bracket?
the garage said they will have to lower the engine a few inches and take off the bolt that goes in the engine. I will just get a whole new arm vs just the wheel.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Allpar Forums
A forum community dedicated to Dodge, Jeep, Ram, Chrysler, AMC owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!