Allpar Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
733 Posts
Discussion Starter · #1 ·
The vacuum lines under my hood are so old that they are cracking that control my heater controls and the on off to the heater core . Where do i get these thin lines?
So far i have been just cutting a black rubber hose and putting the ends inside of it.
It doesnt fit the tightest and the more i repair it the worse it probably gets due to the heat making it bigger and it falls off.

thanks
 

·
Registered
Joined
·
733 Posts
Discussion Starter · #3 ·
that is the one under the hood that keeps getting eaten by the heat. One black that goes to the booster and one gray that goes to the heater core on off.

When i bought the car i got it for a lower price because she said only the defrost works, it was that hose.

I just hope it never breaks off at the firewall. i might have to drill a hole. I should have replaced the whole tube when i had the dash off.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top