Hey guys,
So a couple weekends ago I did a head replacement along with injectors, intake and exhaust manifolds, turbo, etc... A lot of fun stuff in any case, but when I try to start it she's not getting any power to the coil. I've checked the HEP and ASD relay and they're both in working order, so I'm completely stumped! Any help would be great!
The rotor does turb when I crank the engine, the coils is getting nothing with the key on. The only code I had before was a code 13 because I had wired a 3-bar map in a mixed up two of the wires
I validated the ASD by grounding it at the dianostic connector. The fuel pump turns on. This is the 3rd new HEP I've tried and still no luck.
I followed the dianostics here http://www.turbododge.com/forums/f4/f14/358231-no-start-no-spark-84-90-a.html and I've gotten to the end and don't know where to go from here
So I made sure all connections were put back and all grounds were secured when I reinstalled the head. She started when the install was done, but wasn't running properly so I parked her. Came back a few days later and she did not want to start. this was after I rewired the 3 Bar MAP into the system, but I don't think that would cause it to not start right?
I was sure I had wired it in wrong the first time because I was getting a Code 13 and she was running like crap. But I dont think that would explain no power to the coil
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Allpar Forums
A forum community dedicated to Dodge, Jeep, Ram, Chrysler, AMC owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!