Allpar Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
939 Posts
Discussion Starter #1
Any suggestions on the correct incantation and wrench combination to get the O2 sensor out of the swing valve casting in the vehicle? The engine is a 1987 2.2L Turbo 2. I tried every angle I could from under the car and when I can get the special crow's foot style wrench on, there isn't any place I can get a breaker bar or long handled 1/2" drive ratchet and have any swing at all. Car is a 1986 Lebaron convertible, K body and should be the same configuration as a Daytona as far as access goes.
 
1 - 1 of 1 Posts
Top