Allpar Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
67 Posts
Discussion Starter · #1 ·
For anyone who has recently rebuilt a throttle body...does the throttle body rebuild kit come with all the orings needed, such as for the TPS, AIS, etc? TIA.
 

·
Registered
Joined
·
67 Posts
Discussion Starter · #3 ·
Thanks for the tips. Speaking of the injector...should the lower oring fit snugly around the bottom of the injector (in other words, not fall off once inverted)? And should that lower oring be put on the injector or placed in the bottom of the injector housing? I've got two repair manuals and they both say something different. Either way, the injector doesn't seem to be sitting down inside the housing far enough, causing the cap to sit too high. Do these things have to be pressed in with some force?
 

·
Registered
Joined
·
67 Posts
Discussion Starter · #6 ·
Do you remember the size and thickness of the o-ring you used B10alia? If you found one that doesn't leak, would make it a lot easier to know the size beforehand rather than trying to guess at it
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top