Allpar Forums banner
1 - 1 of 4 Posts

· Registered
30 Posts
excellent tutorial,and comments added as well.
this will help many people with the axle replacement.
my only addition would be to mark the brake rotor if you
remove it.
by replacing rotor in its same position on the wheel
studs you minimize the chances of vibration when braking.

i quite often clean the mating surfaces of the rotors
rendering this a moot point.

on some vehicles removing caliper and rotor isnt necessary.
i havent had the pleasure of pulling axles on a PT yet.
so i have yet to try this.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.