Allpar Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I just completed the Bendix 10 ABS Brake retrofit on my 1993 Fifth Avenue. I have been searching trying to find out where to connect the proportioning valve sensor into the existing wiring to shut off the brake light. Can anyone help me on what wire I need to splice into to connect the Sensor wire to?
 

·
What sanity?
Joined
·
3,705 Posts
Gray/black is the wire you should be looking for. Should be in the harness to the ABS modulator. When I got my Imperial the system had already been converted, but I still had to wire this up before it would pass Saskatchewan safety inspection. I also pulled both ABS relays on the driver's side inner fender in the front, removed the ABS module, and wired a new brake fluid level sensor for the EVIC.
 
1 - 2 of 2 Posts
Top