Allpar Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello all, I am new to this forum and this is my first post. Ive done my research on Google but was hoping that someone with experience could maybe save me some troubles and help me out a little. Im looking for some rear quarter panel patches for my 1972 dodge dart swinger. They are pretty much the only thing holding me up from getting her completed...From what ive seen, the lowest is about $150 or so for each side...for some reason I just thought it would be cheaper than that, but maybe thats right. Thank you!

-72swinger850
 

·
Super Moderator
Joined
·
32,317 Posts
I make my own from aluminum sheet metal from Home Depot. A 2 x 3 foot sheet is about 6. Double it up for added rigidity. I rivet and epoxy it in place, after proper rustproofing and priming.
 
1 - 2 of 2 Posts
Top