Allpar Forums banner
1 - 1 of 1 Posts

·
DO NOT FEED THE TROLLS!
Joined
·
1,333 Posts
Dakota manual was only on the four cylinder to my knowledge, so unless you want a K engine I wouldn't suggest that.

An old A833 might do, but might be too light for a truck. There are at least bellhousings and other associated parts for the small block V8.

Tremec makes aftermarket transmissions that can be installed into Mopars, but they're VERY expensive.

I'm a little curious as to your complaint with the original- is "too heavy" because of hefting it in and out of the transmission? Is it physical difficulty shifting gears? Is it pressure necessary to move the clutch?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top