Allpar Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hello. I have a 1990 D150 that is both my daily driver and project truck. I threw away the 3.9 and dropped in an LA 360, and now I want to lower the truck. The problem is the automotive aftermarket seems to offer almost nothing in the way of mods for this truck, which seems odd since Chrysler made them for 21 years! My plan is to use the van lower control arms and the heavy duty coil springs with one coil chopped off. This should drop the truck by about 5 inches. I have heard some rumors about using heavily modified Dakota drop spindles, but can't seem to find anyone who's actually used them. I know I'm going to have to move my upper control arms to restore suspension travel and camber, and what I'm trying to figure out now is steering. Does anyone know how to overcome the bump steer problem? Does anyone make a raised center link, offset tie rod ends, or a set of modified pittman/ idler arms? Are there any factory parts from other vehicles that would be suitable?

Thanks for your input,
Tim
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top