Allpar Forums banner
1 - 3 of 12 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hello everyone

I am in a tough bind here. I just got screwd by a friend that sold me this up van. Any way, yesterday I was out with my 4 kids and all of the sudden , NO BRAKES! Pedal go's to the floor but if you pump it you can get the van to stop. I have looked all over and no leaks at all. I replaced the master cylinder and still no brakes. Just keeps fading to the floor. When I press the brake it makes a air leak sound from the back under the van??? I'm lost here, I have a air leak sound that goes away after 2-3 pumps from a system that is not leaking anywhere, Clean fluid all around after the replacement of the master. I believe the sound might be coming from this piece in the back that I think is a proportioning valve. I think. The sound is being incredibly hard to pin point. I have even tried using a stethoscope on the lines to try and narrow it down.
Please help with some thoughts as soon as possible. I start a new job next week and there is no way me and my wife can shuttle 4 kids with one 4 dr car and get both of us to work! It's Monday and I start next Tuesday!

FYI: I'm an ex mechanic from years back and never had this issue with any of the imports I worked with before, I am capable to do anything so all thoughts are welcome!
 

· Registered
Joined
·
3 Posts
Discussion Starter · #4 ·
Doug D said:
Air leak sound is probably the power booster. That's the only thing I know that would produce an air leak sound. If the booster is bad or leaking, you should still have brakes, but as I recall the pedal will be super hard. Remember sound can be funny in trying to find where it's coming from. It bounces all over the place......
the sound is definitely coming from the center or the back. I tried to unhook the booster to see if it would change but it still made the sound and the low to no pedal effort.
 

· Registered
Joined
·
3 Posts
Discussion Starter · #6 ·
The van does have abs. I seem to be getting no pressure or only a little after pumping it up. I just took both drums of one looked like it had grease all through it . Im going to replace that side piston cylinder n see what happens. I pressed the brake w the drum of n nothing happened.
 
1 - 3 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top