Allpar Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I have a 1988 K car wagon that im replacing the heater core in. One of the mounting posts and some surrounding plastic was ripped from the back wall of the box. I tried a ABS type glue to tack in in to double up with a fiberglass patch w/ resin. But to no avail. Anyone know what resin or epoxy to use? Im of the opinion to use polyester resin as it stays flexible where Epoxy gets hard and brittle.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top